The display was showing 9.1. then 8.9. and is now showing c.l. and seems to be stuck on drain. The original problem we had was that it stayed on all night and had to be manually turned off. When I used it again it seemed that it wasn't getting enough water to spin the arm. I am not sure what part would take care of these issues.
ANSWER Hello Bill,
These units have a flood switch made under the unit in the base assembly. If water down there raises the float even by a hair, the unit will drain the water out and will not complete the washing cycle. The most common cause or the issue is the water inlet valve 00425458 not fully opening, which causes a dribble of water from the fill assembly on the side of the unit. This small dribble accumulates in the main base and generates the issue.
Answered by AppliancePartsPros.com | Tuesday, April 02, 2013