I had a bad control board - the dishwasher stopped mid cycle and the screen was dead. One of the solder joints was loose. I resoldered and replaced the control board. Machine is alive again but the screen and buttons are acting like some sort of control mode. The screen displays the periods (it never did that before). The numbers change depending on what button I press ( 4.8. For power scrub down to .4. For rinse and hold). Also the buttons need to be pressed twice in order to cycle through them.
Is this some sort of programming mode? How do I program his control board?
If it turns out I need to buy a new on - does that one need to be programmed?
The issue that you are having would not be a programming mode but the control board is faulty and would need to be replaced. If there is programming required it will have an instruction sheet included with the control module.
Answered by AppliancePartsPros.com | Tuesday, June 24, 2014