Several of my buttons no longer activate their cycle so I assume I need a new control module. Is this the correct module? It seems one area of the website says it is compatible and then when I check it for compatibility it says it isn't. What should I believe? Also, is this something "easy" to install if you are mechanically inclined?
ANSWER Hello Amy,
The correct control for the model number you listed is 00266746, MFG Part Number: 266746. If you need the jumper wire also, the part number is 00167782, MFG Part Number: 167782. When you get the door panel off and you are ready to remove the control, there are three tabs made on the bottom of the control that have to be depressed to release it from the panel assembly. I start on one end and work my way to the other end. These tabs are on the bottom as you look at the control in position. The hardest part is programming the control. Be sure to check the rinse and hold cycle for 18 to 24 minutes after you get it programmed. To check the program, turn the machine on with the control hanging by the wires, (not on the control panel yet), and the control panel snapped into the door lock position. If the rinse and hold cycle is over 30 minutes, the program you put in is incorrect. If you would like an illustrated instruction sheet, re-post with an e-mail address and we can send it to you. Since it has pictures, it cannot be posted in this format.
Answered by AppliancePartsPros.com | Thursday, December 27, 2012