My dishwasher seems to running fine until it gets to 1 minute left. It continues to run and when I open the door, water is coming out of the arms and the bottom is full of water. The soap door is open and water is not leaking out so it must be draining out or it's recycling the water. When I push the scrub/delicate buttons, it drains and resets to CL. However, when I run it again, it does the same thing and won't stop after 1 minute.
You will want to check all your wiring from the control board down to make sure that there are no broke, corroded or damaged wiring. If the wiring checks ok then the most likely cause of failure would be the control module 00266746.
Answered by AppliancePartsPros.com | Tuesday, May 07, 2013