24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00

Customer Questions and Answers for Control Unit by Bosch

  1. Our Price $384.13
    Compare At $460.96
    You Save $76.83
     
    • Part Number: AP2825913
    • MFG Part Number: 00219640
    • Made by: Bosch
    Add to Cart

Questions & Answers

For Bosch Control Unit (Part Number: AP2825913)

Answer or Comment

View all Questions

At the end of the dishwasher cycle, the dishwasher is not drained, ie the water is still standing in the bottom. Filters etc have been cleaned and pump is working fine. Could this be a fault in the control unit (module) and is this easy for a handyman to replace himself.

John H. for Model Number SHY66C05UC/14

ANSWER Hi John. Get a bucket. Allow the dishwasher to start and put a little bit of water in it. Disconnect the drain hose at the sink. Look inside the hose and clear out resrtrictions if needed. Then use a screwdriver to insert into the sink drain hose connection. Is it plugged there ? Put the drain hose into the bucket. Then press the cancel/drain cycle. It allows the final 2-minute pump out. If not then take the hose off the pump end. Make sure the hose is clear. Look at the pump drain flapper part # []. Is it loose hanging on by a thread of rubber ? Check to see if the pump inpeller is not spinning loose on the motor shaft. If so then replace the pump. Drain Pump Motor Assembly - This dishwasher drain pump and motor assembly has been replaced. If your original drain pump has 9 impeller vanes order 00642239 and 00623143. If your original drain pump has 4 impeller vanes order 00642239 and 00623143. Thank You. 

Answered by AppliancePartsPros.com   |   Friday, April 20, 2012

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify