A few days ago I ordered a replacement drain pump from appliance pros. I received it yesterday and installed it this morning. The installation went well. However when the machine failed to operate with the old pump this is what happened. At the end of the final spin cycle the machine gave the usual flashing CL (complete) message in the LED display and beeped. The clothes were very wet and when removed there was quite a bit of water in the washer. I tried to perform the drain cycle but the machine was stuck in the CL mode and none of the buttons respond. It is still in that mode even after installation of the new pump. Is there a way I can reset the machine? please advise. Your service was great I got my new pump in two days. Thanks for your help.
ANSWER Hello Sam. Unplug for about 30 minutes. If the issue continues, you will need to replace the control board in the unit.
Answered by AppliancePartsPros.com | Friday, August 02, 2013