My question is similar to Douglas' about how to properly attach the wires from the dishwasher to the connector that is now needed to install drain pump #642239. I cannot make sense out of the response given to Douglas because there was no "original" connector. The bottom line is I just have 2 clips that need to be attached to the new connector and I need to know which clip goes on the top and which goes on the bottom when i finally attach the connector to the pump that now has 2 posts situated vertically instead of 4 posts horizontally. my choices are 1 clip has 2 combined wires and the other clip has just one wire.
By the way, it would have been good to know that another $0.74 part, the connector, was needed for this project to be a success. This would have saved down time and additional shipping cost. Just a suggestion to post something about this along with the drain pump part description.
ANSWER Hello Sandra,
The pump is not polarized so the two connectors can connect to either of the two terminals. Just plug them in and the unit will operate normally either way.
Answered by AppliancePartsPros.com | Tuesday, January 29, 2013