Door on affinity dryer has to be raised up to latch
ANSWER Marion, Hopefully your issue is a set of loose hinge screws and not a damaged door or front panel. You may need to remove the loading door " Removing the loading door: Note: To remove the two screws holding the hinge of the door to the front panel, use a small ratchet with a #2 square bit or a right angle Phillips screwdriver. Open the dryer door. 2. Remove the (2) screws that secure the hinge to the
front panel. NOTE: Remove the bottom screw first. Support the door assembly firmly before removing the top screw.3. Remove the door assembly by lifting and pulling outward from unit. 4. Place door assembly face down on a soft flat surface. Then you can check the panels, hinge and door for bent or distorted components, if all's straight and no distortion, you'll need to tighten all the screws and mounts, and re install the door to the front panel and hinge.
Answered by AppliancePartsPros.com | Tuesday, November 27, 2012