I NEED TO INSTALL THIS CIRCUIT BOARD AND NOT SURE HOW TO REMOVE OLD ONE AND OR REPLACE WITH THE NEW ONE. ALSO DIDNT BUY A NEW OVERLAY SO WANT TO REUSE OLD ONE
ANSWER Suzette, " To remove the electronic oven control: 1. Disconnect power from the range. 2. Remove the back panel from the backguard.
3. Disconnect the wires and harness from the control board. 4. Remove the four screws. (One from each corner)". Reverse the procedure and test the control. If you're going to be using the original overlay, you will need to be "extremely" careful removing it from the original control. You may even wish to warm it with a hair dryer to keep it flexible and loosen the adhesive. They have a tendency to wrinkle and roll, and usually don't have a pleasing appearence when installed.
Answered by AppliancePartsPros.com | Friday, February 01, 2013