When I try to turn on the oven the Self-cleaning door lock turns on and cycles thru then I get a error code f-1. I disconnected the power to reset it but I get the same results. Any suggestions?
ANSWER Hello Cesar,
1. Discontinue the electrical power to the range by unplugging the electrical cord or shutting off the circuit breaker associated with the Frigidaire range. Leave the power off for at least 30 seconds and then restore it. If the error is not cleared continue to step two.
2. Access the rear of the unit and locate the flat ribbon connector that connects the electronic range console to the main oven unit.
3. Disconnect the ribbon connector from the electronic range console by pulling out of its slot and leave it disconnected for 30 minutes. The code may be the result of an electronic condition called a checksum error and can be cleared by disconnecting it. Reconnect the ribbon connector, ensuring it is securely inserted into the slot.
4. If this doesn’t correct the issue, the electronic oven control, (clock assembly), 316207520 will require replacement to restore normal operation.
One additional note, if the clock assembly has to be replaced, you can reuse the overlay if you are careful when you remove it from the old clock assembly. Do not pull it up against the glue sharply but pull it while using a knife blade under it, wiggling the blade so the blade is forcing the glue to separate. This will prevent creasing of the overlay.
Answered by AppliancePartsPros.com | Friday, July 06, 2012