I'm getting error code E43. The only result is that the washer will not enter the final spin. I've replaced the door latch and switch assembly as a first test. The washer worked for 2 cycles, then stopped spinning again. I believe this narrows it down to the wiring harness and the control board, but what control board do I need? Is it the control board (134743500) or main control board (137006000)?
ANSWER Hello Nate. You can check the harness to look for bad wires/connections. If all are good, replace the control board on the unit.
Answered by AppliancePartsPros.com | Monday, May 06, 2013