I am having a problem trying to remove this cover I have removed the 3 screws on the bottom, but can not get the upper part off without breaking it. have you any suggestions?
ANSWER Al, Here's some basic dispenser information. " Two gain access to the control area you will need to pull the drip tray out first. With the drip tray removed, remove the 3 screws at the bottomof the front panel. Lift up on the front panel, there are tabs on the top of the panel that slide into holes in the door panel. Swing panel out to side, being careful not to pull the wires out of the disconnect plug or the board itself. Carefully unplug the wiring harness from the touch panel on the front cover. This will give you access to the control board. On models with no selector on the front panel, when you remove the front you can gain access directly to dispenser because you do not have a touch pad or board on dispenser. On models with electronic control to gain access to the control, snap the light socket loose and remove the 6 small screws from the board.Pull board straight out of housing. Disconnect plug on left side of board. Disconnect 4 wires to dispenser actuator switches. With the board removed, remove the 3 screws from the dispenser housing and pull the dispenser forward.Remove water line from dispenser housing by pulling straight out.With the water line removed, the upper part of the dispenser is free of the freezer door panel. The main housing is part of the door panel, and is not removable." This should get you through the repair. Thanks and Good Luck
Answered by AppliancePartsPros.com | Friday, December 30, 2011