Just had an incident. Dishwasher is not draining. I have read the posts only question. What position of rotation should I have the switch while testing for power to the pump?
ANSWER Hi Mw. Just before OFF- the pump will go into a 2 minute drain. Open the door and advance the timer clockwise to one notch before off. Have you're meter lead prongs already set on the pump connector (with the pump disconnected). If you ohm out the drain pump to 28 ohms and each lead to pump chassis to see if the windings are shorted. If they are shorted then replace the pump part # [AP43618633]. If the impeller is spinning loose on the shaft - replace it also. Disconnect the drain hose under the sink and see if the restriction is there at the sink end. Thank You.
Answered by AppliancePartsPros.com | Wednesday, October 03, 2012