How to Find & Install Heating Element for this dryer
ANSWER Hello Muggs. 131553900 is the correct element. You will need to remove, the top, the front panel and door assembly, and drum, disconnect the wires to the element and thermostats, then on the back of the cabinet, you'll need to remove the four(4) retaining screws, that attach the element and housing to the rear of the cabinet. Here's some basic help : Unplug the power cord or remove power to the dryer. Insert a flat tool or putty knife between the top and the front panel and press in on the two spring clips holding the top and raise it. Remove the one screw from each side, located about 6 inches down from the top that holds the front panel to the side panel, release the clips holding the front panel to the side panels and gently lean the panel forward, disconnect the wires to the door switch and drum light, etc. Remove the rear louvered access panel, and remove the drum belt by releasing the tension on the idler pulley. Using the belt raise the rear portion of the drum to release the "ball" from the "hitch" and move the dryer out the front of the cabinet. Disconnect and label the wires from the element, thermostats,etc. From the rear of the dryer, remove the four(4) screws securing the heater assembly to the rear of the cabinet. reverse the procedure(s) and test the dryer for heat and operation.
Answered by AppliancePartsPros.com | Monday, March 03, 2014