The oven heat runs out of control. 2 codes came up, F1 and F10. I purchased and replaced the probe. After I replaced the probe, I put the oven on bake and set the temperature to 200, the broil element comes on but not the bake element. The broil element does not shut down at temperature and continues to rise. What part should I replace next?
ANSWER Hi Lonnie. F1-F10 Runaway Temperature. (F10 only) Check RTD Sensor Probe & replace if necessary. If oven is overheating, disconnect power. If oven continues to overheat when the power is reapplied, replace EOC part # 316557200. Severe overheating may require the entire oven to be replaced should damage be extensive. I would use a volt/ohm meter part # TJMA-DM1 to assist. you in your diagnosis. Oven Sensor part # 316490001. Thank You.
Answered by AppliancePartsPros.com | Friday, March 23, 2012