24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00

Customer Questions and Answers for Pump and Motor Assembly by Frigidaire

  1. Our Price $56.59
    Compare At $95.93
    You Save $39.34
     Watch Video
    • Part Number: AP2106445
    • MFG Part Number: 131268401
    • Made by: Frigidaire
    Add to Cart

Questions & Answers

For Frigidaire Pump and Motor Assembly (Part Number: AP2106445)

Answer or Comment

View all Questions

As others have explained, my washer will not spin. The tub fills, the timer moves but the tub will not move. It does not wash, or spin. The timer goes tru the cycle, tub does not spin. It sucks out the water then it shuts off.

Anthony for Model Number FWTR445RFS0

ANSWER Hi Anthony. Find the wiring diagram under the top and/ or inside the cabinet folded up in a packet. The wiring diagram we see is too smudged to figure the colors of the wires going to the pressure switch. The tub fills and then the goes connected to the pressure switch is sensing the water fill and pushes the displaced air back up the hose and allow the pressure switch diaprahm to close the contacts and allow the motor to run. You can figure the common terminal (feed) and jumper that wire to the closed (fill) terminal on the pressure switch to see if as thew door is shut and it is on a low fill setting with water then the unit should run. Use a volt/ohm meter part #@ TJMA-DM1 to assist you in your diagnostics. Unhook the pressure switch hose. Blow back into the tub and see if you blew out any restriction. Lint ( a clogged dryer vent system) will get into the hose and not allow proper switch sensing operation. Take another hose the same size and hook it onto the pressure switch. Keep the original one hooked up to the tub taped tight to the back of the controls area so it does not fall and leak while testing. At the point to where you think the timer is set to run with a low water fill and the door closed, blow into the switch. It should close the diaprahm contacts and allow motor to run. If it does not then you need a pressure switch part # 134433701. You can do this procedure instead of the jumper of the wires if desired. Let us know if we can help you further. Thank You. 

Answered by AppliancePartsPros.com   |   Thursday, May 10, 2012

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify