I am having trouble with the water flow into the icemaker. It worked for a while. I have misplaced the instructions on how to turn the screw for the water flow and for how long it should flow. I do that and have to turn it back off to stop the water flow and then no water comes back when that dumps.
ANSWER Hi Cps. The screw corresponds to small hole in the front of the module. It has a brass metal tab with a hole punched out in the middle. The factory sets the screw adjustment so the hole is in the middle. This gives the proper 7 seconds of water fill = 113-151 cc, 4-5 0z. Rotate the side screw 180° counterclockwise puts the "hole" to the Left outer edge. I remember it as "left -let's in"... Then turning the screw clockwise 180° allows the hole to go to the rt. side as "Rt. - restricts". Any further in either direction will over flow or break the internal module parts. I have always adjusted to the rt. so the cubes are a little smaller so they come out of the chute easier and not clump up. Thank You.
Answered by AppliancePartsPros.com | Wednesday, July 11, 2012