24/7 Customer Support

:

Customer Questions and Answers for Seal, Tub by Frigidaire

  1. Our Price $43.39
    Compare At $51.63
    You Save $8.24
    • Part Number: AP2142342
    • MFG Part Number: 5303279394
    • Made by: Frigidaire
    Add to Cart

Questions & Answers

For Frigidaire Seal, Tub (Part Number: AP2142342)

Answer or Comment

View all Questions

i have full size Gibson stack able last few times i used noticed it was louder than usual.it fills with water agitates sucks out water DOES NOT SPIN!I took out the screws on the little brackets unplugged some wires only to find that if i took out the screws on each side in the front (there is one screw on each side in the front)then the top lid and cover lifted right off.so the dryer just sitting there.i got the bolt out of the top of agitator(only after using a penetrating spray)removed agitator then i thought drive block but not sure it had half inch bolts like half moon around spindle with a flat piece on the back that the half in bolts pulled tight up to or on the spindle not really sure where to go from here. i did however find 4 small screws under agitator and on the inside of agitator a bunch of lint .i I was amazed at what i saw under the agitator youd think it would be clean.Down on the bottom side i noticed about a quarter of a inch looked like someone took a knife and made a slice in agitator actually had to use needle nose pliers to remove lint out of cut Any and i mean any help greatly appreciated have nice day

Iblashaun for Model Number GLSE62RHS0

ANSWER Iblashaun, Did you remove the tub cover and check for an article(s) stuck between or under the spin basket ? It does sound more like a tub bearing 3204405, 5303279394 issue or a failed transmission 134736400 , at this point. We'll be sending you somee additional information, that should be helpful. 

Answered by AppliancePartsPros.com   |   Thursday, October 11, 2012

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify