24/7 Customer Support

:

Customer Questions and Answers for Thermostat by Frigidaire

    • Part Number: AP2107111
    • MFG Part Number: 131539400
    • Made by: Frigidaire
    • Not Available

Questions & Answers

For Frigidaire Thermostat (Part Number: AP2107111)

Answer or Comment

View all Questions

Could this cause my dryer to not want to heat up? I change the gas coil valve and the ignitor already. I missed this thermostat and the top one when I did my multi meter. The top read fine but this one doesn't read anything at all.Thanks

Mike for Model Number FDG336RES1

ANSWER Mike, Yes, an open thermostat circuit, would keep the dryer from heating. The thermostat should have a "closed" circuit at room temperature across the two "lower" terminals(pink and orange) and 7 K miliohms across the "upper" terminals (pink and blue) with the wires disconnected. Thanks and Good Luck 

Answered by AppliancePartsPros.com   |   Thursday, February 09, 2012

ANSWER Hi Mike. Do you have access to a clamp on amp meter ? If so then clamp it on the red wire going to the igniter (or one of the 2 wires). Then tape the door sw. shut and see if the igniter glows as it pulls between 3.2-3.6 amps. It also should read cold at 50-800 ohms, not open this is part # 5303937186. The thermostats should all read closed part # 131539400 the inner 2 wires (or the 1-inner -to-outer terminal) should read a resistance reading for a heater resister is 50k ohms (the 2- blue wires connect). Thank You. 

Answered by AppliancePartsPros.com   |   Thursday, February 09, 2012

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify