Frigidaire front load washer. Broke a shock and replaced that. Pump runs free and clear.Washer works good on every cycle, but have to advance timer by hand. Replaced timer ,as it was suggested on other page but have same result. Control board fuse is not blown. Is there any other sensor that would cause this? Any more ideas? Thanks.
ANSWER Hi Lebert. Due to interference from a older timer with dirty contacts it will induce electrical interference noise into the speed controller and stall it which stalls the timer until manually advancing the timer yourself. The new speed control comes with a jumper harness that stops ll the noise and stop the issue altogether. The speed control part # is 134149220. Thank you.
Answered by AppliancePartsPros.com | Thursday, September 15, 2011