I've had problems with the water/ice dispenser. For awhile the ice maker worked, but then started to fail, with display buttons blinking and locking up the panel. After a few hours the panel would function again, but now only for water. Eventually that functionality stop all together, so I purchased and install a new display board. The IDA will not light up as if there is no power going to it. I checked MCB to see if anything was blacken/burned. None looks new. I had this replace once before. Since the MCB was replaced I found one of the wires in the wiring harness at the bottom of the freezer door croaded through and wet. So I spliced it back together and IDA worked for a while then it stop. When the repair tech replace the MCB he the press a series of buttons on the IDA to reset it. Can not find the part # for wiring harness. Any ideas??
The wiring harness that is located at the bottom of the door is part of the door and if on the cabinet side is part of the cabinet. If the wiring harness is on the freezer door side then the freezer door would have to be replaced. If the wire harness needed is on the cabinet side of unit then it cannot be gotten as it is foamed into the cabinet of the unit.
Answered by AppliancePartsPros.com | Tuesday, April 16, 2013