I have asked questions previously and those questions can be found on the interface assembly section and also in the mother board question area. After trying the interface and mother board and getting no results, I did check the wiring, as you suggested, futher and discovered one of the connectors was bad on the bottom of the freezer door and the interface panel started working.. Now the unit is not maintaining temperatures. I have set the temperatures for the freezer and the refridgerator for the factory settings but when the adjustment settings part cycles off on the interface panel and I check the temps again I find that the are showing settings of 46 degrees in the refridgerator and 36 in the freezer section. The dispenser is working as it should so why can't I adjust the temperature. I don't know what else to do this is getting very frustrating. You have been most helpful in my two previous questions. I hope you can help with this. It appears when the unit does come on the fan does not run. Thanks for any help you can provide.
ANSWER Hello Bruce. It sounds like the readings are of actual temp inside the unit. This is normal. Once it cools down to the correct temp, then they should read the settings you have programmed. If there is still issues, you will need to check and make sure the main board is installed correctly and connections on the interface and main board are tight.
Answered by AppliancePartsPros.com | Monday, June 17, 2013