CAN YOU PLEASE give me procedure for installing a new Trim for recess dispenser part number GE AP3183688. I'm guessing that access is from inside freezer door and inside panel must be removed. Thanks much.
ANSWER Erik, I think this will be a help, it's basic instrutions, but should get you through, " The dispenser assembly consists of the interface, display board, dispenser shield, and duct door functioning parts. The dispenser interface can be removed to access the display board and the dispenser shield mounting screws. The interface is held in place by 4 tabs that hold it to the dispenser recess. To remove the interface, it is necessary to grasp the bottom lip of the interface on either side and gently pull it towards you. There are 3 wire harnesses connected to the display board. Note: The interface and display board are replaced as a complete assembly. When assembling, insert top tabs into the top of dispenser recess fi rst, then snap the bottom into place.The dispenser shield can be removed to access the cradle switch, duct door, duct door solenoid, and dispenser LED lights. The dispenser shield is attached to the dispenser recess with 4 Phillipshead screws." Thanks and Good Luck.
Answered by AppliancePartsPros.com | Wednesday, July 27, 2011