I need to replace the Tub Bearing for my GE Washer Model # WCSE4160B1ww. I can't figure out how to remove the top part of the agitator to get to the bolt. I've read using a screw driver and pry off the top or simply pulling. I don't want to break it getting it off. Any suggestions. Thanks.
ANSWER Pat, The agitator WH43X10034 is a "snap" lock fit onto the agitator coupling WH49X10042 . You grasp the bottom of the agitator with your fingers and lift or snatch up, the agitator locking tabs should relese and you can lift the agitator up and out. You can also use an old belt, length of rope, or tie down strap, slip it under the agitator, and pull up on the belt or strap, you may have to do this two or three times, around the circumference of the agitator bottom, to braek it loose from the coupling.
Answered by AppliancePartsPros.com | Friday, November 02, 2012