24/7 Customer Support

:

Customer Questions and Answers for Water Inlet Valve by GE

  1. Our Price $19.24
    Compare At $47.84
    You Save $28.60
     Watch Video
    • Part Number: AP3189335
    • MFG Part Number: WR57X10033
    • Made by: GE
    Add to Cart

Questions & Answers

For GE Water Inlet Valve (Part Number: AP3189335)

Answer or Comment

View all Questions

Can the water inlet valve be taken apart and cleaned? Can the tube to the ice maker be pulled out and pushed back in at this valve? It seems that the valve is not fully shutting off because I find an ice column from a slow drip from the bottom of the ice maker to the ice cubes below. If I break it off twice a day it works fine but if I don't, I get a block of ice in the tray.

Jay M. for Model Number gth18ebtzrbb

ANSWER Hello Jay, The water valve cannot be taken apart and re-assembled. If you do this, it will have an external leak that cannot be repaired. The water valve will have to be replaced. The only thing that can cause the valve to not fully close is low water pressure since the water pressure closes the valve, or a bad water valve, (fouled by sedimentation and/or mineral deposits from the water supply). The water line is removed by pushing it into the valve hard and holding the ring around the water line in toward the valve. While holding the ring toward the valve, pull the water line out of the valve. This is called a John Guess fitting. The line is re-installed by pushing it into the valve until it bottoms. Pushing it a bit harder will make the line bottom again. Pulling on the water line at this point seats the seal. As a note, if there is a dip around the water line, it has to be cut off squarely, (about 1/4 of an inch), to prevent a leak since this is where the seal seats. Replacing this valve will correct the issue of the ice column. 

Answered by AppliancePartsPros.com   |   Friday, July 05, 2013

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify