So the video was great and I just changed out my bearings and seal. Hooked everything back up and now when I try to run the washer it wont run. When I hit the start button all the cycle selector buttons are lit and it when I spin it it wont let me select any of the cycles, they all stay lite. The start cycle button flashes but that is all that it will do. Any thoughts??? I know I did not miss hooking up any of the wires but any help would be appreciated. Also the machine ran fine until I took it a part to do the bearing job.
ANSWER Hello Kevin. You need to check those wires again. Check the door lock on the unit. If a wire is bad or not connected good, you will have this issue.
Answered by AppliancePartsPros.com | Thursday, August 07, 2014