I have a Lg washer about five years old and it is in a very good shape. It stop working and I open at the back of the machine and push the drum four time and the machine wash five load. The next morning it went to the same problem. I replace the hall sensor. Now the machine does not agitate, or spin or wash the clothes. I follow the yellow, red and blue wires from the control board, I cant seems to get 120 come out. I unplug the wire harness and check the ac, I was not able to get 120 volt.
ANSWER Hi Chibe. You are on the right track. It will be advantageous to find the supplied tech sheet inside the cabinet to aid you in the diagnosis. It allows you to put the unit in a diagnostic mode which brings up fault codes and tells you which circuit needs assistance. Use a volt/ohm meter part # TJMA-DM1 to assist you in your diagnostics. What code's are showing now? Disconnect the motor connector and measure the terminal resistance. From pin # 1-2 , # 2-1 and # 3-1 you need to have 5-15 ohm resistance. If the measurements are different then these, replace the stator part # 4417FA1994G. Drive Motor Stator Assembly - This front load washer drive motor stator includes the rotor position sensor switch (RPS). For the RPS switch only order 6501KW2002A. Thank you.
Answered by AppliancePartsPros.com | Monday, October 01, 2012