I have an LE Error Code on my Washer and need to know the correct Ohm reading (maybe 10,000 or 10k) that I should get on the RPS/Hall Sensor Assy. (include which 2 wire's/pin's to check with Multimeter).
I have a Service Manual but it doesn't list a wiring diagram to check for resistance/voltage.
With Power ON, I get 10 DCV on the White & Gray Wire's (on the RPS harness connected to Main Power Board) but I only get between 4-5 DCV on the Blue & Gray and Red & Gray wire's while slowly rotating the drum both direction's (CW & CCW).
ANSWER Hello rockinrobin. They do not offer that info, but if you use page 25 in the manual you can test the motor. If it is good, then it is the sensor.
Answered by AppliancePartsPros.com | Wednesday, July 03, 2013