Note: This question is for the older version of this part, but we thought you might still find it helpful
I get a 1E error. I'm ordering a new inlet vavle. The sheet with codes says possible impeller of Air Guide is bound. What or where is that? The Hall sensor is OK? What or where is that? Replace the Air Braker. What or where is that? None of these parts are on your parts lists. The unit is low on water, and sucks air. When I open the door to add more, it runs OK until the next cycle, then repeats. There is now a high pitch whine when washing. Drain works OK. Did I lose a pump bearing on low water? Drain is OK, and goes through an air break. It does not syphon. Changed water hose and checked supply, seems OK. Unit is level.
ANSWER Hello David,
The hall sensor on unit would be part of the motor assembly. The air braker would be a long dome that attaches to the side of the wash tub. There would be a nut on the inside to allow removal. With the unit making a high pitched wine it sounds like the motor bearings are bad.
Answered by AppliancePartsPros.com | Tuesday, December 04, 2012