I received an error message Not Draining check the drain pump filter. I checked/cleaned the debris filter and tried to spin out the load. The machine made quite a bit of noise and near the end of the spin cycle again gave me the error message. I pulled the washer out, found the instructions for quick tests and ran the test for circulation/drain pump. The circulation was fine but the drain did not drain - it however did not give me any codes whatsoever. Do you think it is likely a drain pump issue, an electrical issue (control board) or what??? How do I figure this out?
ANSWER Hello Kelamc. Test and see if there is power coming to the drain pump. If so, and it does not run, replace the pump in the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
Answered by AppliancePartsPros.com | Monday, March 31, 2014