I have no heat in the dryer. The diagnostic code 2 repeats every cycle after cleared. I removed the thermistor and it ohms out at about 9k ohms so I backed probed the wires at the control board with the thermistor plugged in and got the same reading. Suggestions?
ANSWER Hello Bob,
The thermistor is reading close enough to be correct. It should read 10K at 77°F, so 9K should be correct at about 70°F. I believe since you have troubleshot the wiring, that the issue will have to be the circuit in the control board (AP4045210) that reads the thermistor information.
Answered by AppliancePartsPros.com | Tuesday, June 25, 2013