maytag washer LAT2500AAE. followup to previous emails replaced brake assembly to a no spin problem. no luck. took off belts. turned pulley counter clockwise-agitator turned easily. clockwise-after extreme effort, spin basket turned a little. then no more. never really checked the radial bearing. it was clean with no rust. could i have installed brake assembly wrong. no clear picture in downloaded manual. rounded/dome side of trans/pulley bearing if facing brake.
ANSWER Don, The Ball Bearing 200835 is installed correctly, as long as the Radial(rear) bearing 22003441 is seated in the brake package properly, and the brake package is installed as tight as possible, and locked in place with the retainer clip and bolt 213325 213326. If you're sure the drive lug 211089 is adjusted properly, then you will have to check and replace the tub bearing 6-2040130 and tub seal kit 6-2095720 TJ90TB123A The bearing has seized to the transmission race, and will not allow the tub to spin.
Answered by AppliancePartsPros.com | Friday, March 22, 2013