WHAT IS THE PROCEDURE FOR INSTALLING PARTS #AP4354881 SLIDE,#AP4451249 AND #AP4450387 BRACKETS IN THE FREEZER ?? THE PARTS HAVE BEEN PURCHASED FROM YOUR COMPANY AND HAVE RECEIVED SHIPMENT. THANK YOU FOR YOUR HELP.
ANSWER CJ , Here are the basics " DRAWER ASSEMBLY 1. Open drawer to fully open position. 2.Remove upper baskets. 3. Remove screws one on each rail marked on side of rail. 4. Lift front of drawer up and out to remove drawer. DRAWER RAILS 1. Remove screws inside plastic rail retainer. 2. Remove rails from retainer by depressing plastic tabs on back side of retainer. 3. Slide rails off of retainer. RACK AND PINION GEAR 1. Remove drawer assembly(see Drawer Assembly Removel) 2. Extend drawer rails to full open position and remove rails from retainer by depressing plastic tabs on back side of retainer. 3. Slide rails,rack and pinion gear off retainer. 4. Reverse procedure to reassemble. NOTE: When reinstalling rails,rack and pinion gear after latching rails in place, slide rails, rack and pinion to fully closed position and then pull out several times to synchronize the rack and pinion gears."
Answered by AppliancePartsPros.com | Wednesday, August 22, 2012