24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00

Customer Questions and Answers for Cam Bar, Spin by Whirlpool

    • Part Number: AP3098458
    • MFG Part Number: 350532
    • Made by: Whirlpool
    • Not Available

Questions & Answers

For Whirlpool Cam Bar, Spin (Part Number: AP3098458)

Answer or Comment

View all Questions

Ser # C30236892. Note: trouble on WARM/HOT water temp only. Trouble clears on COLD setting. Trouble: after water level is reached, agitation starts, but water is still entering the tub. It stays on, even when it reaches the top and overflows. My temporary remedy is to turn off supply valves, then turn them back on to same pressure. They will remain off until the cycle calls for water again. Same trouble with rinse and spin. Supply is manually turned on and off during the spray rinse cycle while tub is spinning. Otherwise the load is too damp at close of cycle. QUESTION: which part(s) are faulty in this scenario? Thanks.

Char for Model Number 110.82172120

ANSWER Char, The water valve would be the cause of the unit not stopping the filling of water. You will want to check to make sure that the screens are not clogged. If the screens on the water valve are clogged clean and check to see if problem persists. If problem does persist then you would need to replace the water valve 358277

Answered by AppliancePartsPros.com   |   Wednesday, April 24, 2013

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify