AT THE END OF THE SPIN CYCLE THE WASHER MAKES AN UNUSUAL CLANKING NOISE. I CHECKED THE TUB AND NOTICED I COULD PULL UP ON THE TUB SEVERAL CENTIMETERS AND THE TUB SITS TOWARD THE RIGHT WHEN STOPPED( WILL NOT STAY CENTERED). IT DOES NOT LEAK WATER. DO YOU HAVE ANY SUGGESTIONS TO LOOK AT FOR REPAIR.
ANSWER Don, The "clanking noise at the end of the spin cycle is most likely the drive block 389140 rotating on the drive tube 285792 because the drive block tab slots are worn out, when the brake and tube stop, the drive block and tub continue to rotate. The tub sitting off to one side is usually due to a loose or broken suspension spring 63907 or bracket, or in some cases the tub has gone off balance, and over rotated and the skid plate and pads are "hung up" and not allowing the tub to re center properly.
Answered by AppliancePartsPros.com | Wednesday, July 24, 2013