I had the clean vent filter code pop-up on my over-the-range range microwave. I cleaned and replaced filters and the "Clean Filter" still pops up. Is there a way to reset it?
ANSWER Hello Marty,
Reset the filter status after replacing and/or cleaning the filters. Touch Options or Setup control to reach the “Filter Reset” sub-menu and activate reset. To reset control, dis-continue power supply to the unit for 2 minutes and power it back up. If the problem persists, the control board W10211457 will most likely require replacement since the EEPROM read only programming information on it is probably corrupted.
Answered by AppliancePartsPros.com | Friday, February 22, 2013