24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00

Customer Questions and Answers for Circulation Pump and Motor Assembly by Whirlpool

  1. Our Price $195.41
    Compare At $232.54
    You Save $37.13
     
    • Part Number: AP3083251
    • MFG Part Number: 2217220
    • Made by: Whirlpool
    Add to Cart

Questions & Answers

For Whirlpool Circulation Pump and Motor Assembly (Part Number: AP3083251)

Answer or Comment

View all Questions

Update on my problem 1.When I turn on my icemaker is goes through a full cycle 2. The cutting grid is warm ready to cut - working fine- Problem starts to occur - No water. 3. When in the icemaker calls for water to circulate over the freezing plate to begin the water freezing process - No water circulates over the freezing plate. What parts do I need ? a. control board b. water pump c. solenoid. Where should I start ????

Randy Q. for Model Number KUIA15NRHS5

ANSWER Randy, As I understand this, the icemaker does not fill the reservoir at the start of the cycle, so the unit does not fill and circulate the water over the chill plate to make cubes, correct ? The first place to start, make sure there is water supplied to the fill valve, and the fill valve screen is not clogged with debris, Then run the Diagnostic/test Mode, "Entering and Navigating — Manual Diagnostics • Turn the product on. Within 10 seconds of Power On, press and hold the On and the Clean buttons. Release both buttons when all user interface LEDs begin to flash. • Within 5 seconds of all LEDs fl ashing, push any other button on the user interface. This begins manual diagnostics. • If no button is pressed within 5 seconds, the product goes into the automatic diagnostic mode used at the assembly plant. Each component is cycled for 5 seconds. • The Service button (or Off button on some models) is used to advance through each step. • To exit manual diagnostics, press the Power button (or On button on some models).These errors will occur at any time during normal operation if a thermistor fails. 2 Blinks — Service Light is blinking twice in repeating intervals – This signifies a bin thermistor failure. Check that the bin thermistor is plugged in to the control box. Check that the bin thermistor is not open or shorted. Replace the thermistor if it is open or shorted. 3 Blinks — Service Light is blinking three times in repeating intervals – This signifies a harvest failure. Check that the evaporator thermistor is connected to the sealed system tubing. If the thermistor is plugged in, ensure that it is fully connected to the control box. (The ice maker will operate on a timed cycle if the evaporator thermistor is unplugged.) Check the resistance of the thermistor. If the thermistor checks good, then look for a frost pattern on the evaporator plate.The unit may be low on refrigerant." this will give you and us a better idea of what may be the problem. Thanks 

Answered by AppliancePartsPros.com   |   Tuesday, April 12, 2011

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify