24/7 Customer Support

:

Customer Questions and Answers for Clock W/ Harness by Whirlpool

  1. Our Price $297.50
    Compare At $357.00
    You Save $59.50
     Watch Video
    • Part Number: AP4098388
    • MFG Part Number: 74007217
    • Made by: Whirlpool
    Add to Cart

Questions & Answers

For Whirlpool Clock W/ Harness (Part Number: AP4098388)

Answer or Comment

View all Questions

What does it means when you get an error code F-1 and F-3. I replaced the oven sensor and thought that will solve the problem but it didn't. The oven shuts down with error F-1 and sometimes error F-3.

Carl for Model Number JGS8850ADW

ANSWER Hello Carl! An F3 error indicates a shorted or open sensor. Check the wiring between the clock and the sensor to make sure it is ok. The F1 indicates a defective or shorted touch pad or clock. The clock is part number 74007217 and the touch pad is part number 74005740. You will need to run the following test (below) to see which part to replace. Hope this helps, thanks! This simple test will help determine whether the ERC (Electronic Range Control or Clock) or the touch pad is defective when F1 error code is present. Note: Some models incorporate the touch pad in to the ERC as a single assembly, in which case this test is not necessary. Simply replace the ERC (Clock). Warning: If you feel in any way uncomfortable performing this test or making this repair, please contact a qualified appliance repair technician. 1. Disconnect power to the range (unplug the range power cord or turn the power off to the range at the circuit breaker). It is very important that the power to the range has been disconnected, so please double check before continuing. 2. Gain access inside the control panel. 3. Disconnect the touch pad (also called keypad or membrane switch) ribbon from the ERC. 4. Make sure there are no lose wires, or anything else that may cause a short when power is turned back on. Assemble the control panel back the way it was. 5. Turn the power back on. 6. Wait for at least one hour to see if the F1 code comes back (usually accompanied by a beeping sound). 7. If F1 comes back, replace the ERC. If it does not, replace the touch pad. 

Answered by AppliancePartsPros.com   |   Tuesday, January 31, 2012

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify