My washer throw a code f5 I think and it lost power and left door locked repair man came out and got it unlocked and tested machine and said it was control panel I just replaced it and it still has no power to control panel . it has power into box the panel plugs in to.
ANSWER Hello Mike,
If during the water heating step in the wash cycle, the water temperature sensor (NTC) value is out of range, the “F/05” error code will be displayed. Possible Causes / Procedure 1. Unplug washer or disconnect power. 2. Check the water temperature sensor. Refer to the
Water Temperature Sensor section, page 11 of the units' tech sheet. Check connections to the water temperature sensor. 3. Check resistance of heating element, if present on this model (abnormal = infinity).
Water Temperature Sensor
1. Unplug washer or disconnect power.
2. Disconnect the wire harness from the water temperature sensor and measure the resistance of the sensor. Use the table on the units' tech sheet page 11. An abnormal condition is an open circuit.
Answered by AppliancePartsPros.com | Thursday, May 09, 2013