24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00

Customer Questions and Answers for Electronic Control Board by Whirlpool

  1. Our Price $133.89
    Compare At $159.33
    You Save $25.44
     
    • Part Number: AP4564002
    • MFG Part Number: W10285179
    • Made by: Whirlpool
    Add to Cart

Questions & Answers

For Whirlpool Electronic Control Board (Part Number: AP4564002)

Answer or Comment

View all Questions

Water fill valve does not open during the "Rinse and Hold" cycle, but it does open properly during nall other cycles. What could be the problem?

Giorgio for Model Number GU2300XtvQ1

ANSWER Giorgio, Based on your post information, your most likely issue is a "glitch" in the control board fill valve circuit or the "chip" in the control board W10285179. You may want to try conducting the service diagnostic cycle to reset the control " To invoke the Diagnostics Cycle, perform the following key presses or actions in less than 6 sec while in standby: Heated Dry ? Normal ? Heated Dry ? Normal " allow the cycle to advance until it shuts off. " Invoking Service Diagnostics clears all status and last ran information from memory and restores defaults; It also forces the next cycle to be a sensor calibration cycle." If the issue persists, then replace the control board. 

Answered by AppliancePartsPros.com   |   Tuesday, January 08, 2013

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify