When I reset control board (W10285180) all lights com on but the WASH light. With machine set at normal wash/heated dry,I get a normal fill cycle . Then starts washing, but the washing light does not come on. It seems to wash forever. The soap dispenser does open, but does not go into heated dry cycle. I think it just fills, wash, drain, fill, wash, drain. It will run like that for an hour and a half or so until I press the cancel /drain button, then it stops ,drains and turns off. Thanks for the help.
The dishwasher will run anywhere from 99 minutes to 2 1/2 hours. There are factors that go into this like the water temperature in the unit and how long it takes to heat the water to 140 degrees. The unit should have 120 degree water in the tub after fill which will reduce the time that the unit takes to heat the water to proper temp. The unit will time out of the heating process in approximately 20 minutes if the temperature has not gotten to 140 degrees. For the issue of the wash light not coming on, you will want to check to make sure that the ribbon harness from the keypad is seated properly but you may need a new control panel.
Answered by AppliancePartsPros.com | Thursday, May 09, 2013