The Maytag dishwasher is less than 3 years old. The dishwasher shows no lights nor signs of life when any of the mode buttons are pushed. Will replacement of the control module Whirlpool p/n W10250166 correct the problem ? The mother board appears to be receiving power for when I unplug, then reconnect the 2 leads to the capacitor there is a spark. Also, when I do this the dishwasher will run part of a cycle for a minute then die again.
ANSWER Hello Glenn,
You may want to check to make sure that your thermal fuse W10258275 is not bad. If it is good then you would need to replace the control board W10298356. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
Answered by AppliancePartsPros.com | Thursday, November 08, 2012