I tried running the diagnostic test with the clean button. There are NO LED's on the face panel of my ice maker - just on - off - clean buttons - the only LED is the clean light - no blinking. (are the LED's located any where else)
Update: I ran the ice maker today three seperate times lets call it test 1, test 2, and test 3
Test 1 result: the unit ran fine for aprox 2 1/2 - 3 hrs made ice went through 3 full cycles - after the third cycle the unit shut down. i noticed alot of heat coming from the lower section of the unit where the fan, compresor and condensor is located. during cycle 2 and 3 of ice making the fan ran very slow and at times shutting off and on
Test 2 results: same as test 1 ( I let the unit cool down for 1 hr before starting test 2)
Test 3 results: same as test 1 ( i let the unit cool down for 4 hrs bfore starting test 3)
Thought / suggestions / ideas
ANSWER Hi Randy. Press clean Sw. for diagnostic mode. To exit clean/diagnostic cycle press "off " to reset control. A.= Flashes here 2x if there is a bin thermistor fault. B.= Flashes here 5x if there is an evaporator thermistor fault. C.= LED will pause 3 seconds here. In "Harvest mode" the water valve will shut off after one full minute. Total time in harvest mode will vary. The minimum harvest mode is 1 minute / maximum is 16 minutes. In "ice making mode" the freeze interval will be 15 minutes to 25 minutes maximum. Thank You.
Answered by AppliancePartsPros.com | Thursday, February 16, 2012