My Maytag SG1000 washer is constantly going to the "pause" light indicator. It was working fine and now it won't engage the wash cycles (if I hit the "pause/resume" tab 100 times, sometimes it will work).
I managed to get a load of clothing going (after hitting the "pause/resume" over and over) and it stopped working at the spin cycle.
I got the individual "spin" tab to start this cycle again but, it stops half way through and goes to the "pause/resume" light/tab.
I think the control board may be malfunctioning.
ANSWER Matt, You'll need to remove power to the stack set, and remove the front panel off the washer. You'll need to check the micro switch 10533003 and wires on the lid latch assembly. You'll also want to move the washer out far enough to access the umbilcal cord, disconnect it and check to make sure the pins and receptacles are all clean and properly seated and locked in place. These are low DC voltage circuits, and it doesn't take much to make them "fail"
Answered by AppliancePartsPros.com | Monday, January 07, 2013