Machine will add cold water to start load cycle then as it needs to add water it will only add hot water even if the load controls are set for cold wash and cold rinse. If you shut off the hot water supply it will not add any water at all. I have pulled water supply lines loose and checked for obstructions at the fill valve screens and hoses. All is open and free flowing there, would the dual fill valve be bad possibly only on the cold water side? The only way we get any cold water in the machine after initial cold water fill on any load setting is to set machine to rinse and spin only. Showed an error code one time of HF before pulling hoses and cleaning screens and have'nt had that show since, but still not getting cold water added to any wash cycle?
Chuck for Model Number GHW9100lw1
ANSWER Hello Chuck,
You would want to check the water temperature sensor to make sure that it is good. If the temperature sensor checks ok then you would want to check the wiring to CCU and to valve. Here are the value and how to check temperature sensor.
Water Temperature Sensor
Disconnect the wire harness from
the water temperature sensor and
measure the resistance of the
sensor. Use the following table.
An abnormal condition is an open
circuit.
Temp. Results
32°F / 0°C 35.9K O
86°F / 30°C 9.K O
104°F / 40°C 6.6K O
122°F / 50°C 4.6K O
140°F / 60°C 3.2K O
158°F / 71°C 2.3K O
203°F / 96°C 1K O
Answered by AppliancePartsPros.com | Friday, January 04, 2013