When any of the cycle buttons are pushed, the dishwasher's display lights but the dishwasher does nothing. After the usual amount of time it takes to complete the cycle, the display light turns off.
I tried pushing the "Normal" cycle button, waited a few minutes, then pushed the "Cancel" button. The dishwasher does nothing; but after pushing the "Cancel" button, a few minutes later the display light turns off (as though the dishwasher has completed canceling the cycle).
Thank you in advance for your assistance.
ANSWER Hello Dan,
You need to check that nothing is holding the float switch in the up or raised position. If this is good, check the electrical connections to the water inlet valve. You should be reading 120Vac. If so and the unit is still not filling with water, replace the water inlet valve 3374621. Locate the tech sheet on the appliance and it will help more than I can help.
Answered by AppliancePartsPros.com | Thursday, December 27, 2012