24/7 Customer Support

:

Customer Questions and Answers for Control Board by Whirlpool

  1. Our Price $180.17
    Compare At $216.20
    You Save $36.03
     Watch Video
    • Part Number: AP3775585
    • MFG Part Number: 8564547
    • Made by: Whirlpool
    Add to Cart

Questions & Answers

For Whirlpool Control Board (Part Number: AP3775585)

Answer or Comment

View all Questions

I have the blinking clean light problem. Can do the reset and the light goes out sometimes most of the time it will not complete all the cycles and dishes are dirty when it stops. Then sometimes after I do the reset and cancel it does fine like it is supposed to. The element is working because when it completes the cycle and when it's finished and you open the door steam hits you in your face so I would think the element is working? Was thinking about trying a control board, but being they are pricy though I would ask first. I'm fairly handy already opened the front to check connections on the board and door switches all good still has same problem clean light flashing slow wont sratr until you do a reset. My hot Water heater is set at 125 degrees.

Mike W for Model Number GU2400XTPB6

ANSWER Hello Mike. Make sure you get the water hot at the sink before starting the unit. If so, and the issue continues, you will need to replace the control board in the unit. As for the dirty dishes. Make sure the spray arm holes are clean and clear and the water is filling to the bottom of the heater. 

Answered by AppliancePartsPros.com   |   Tuesday, June 24, 2014

We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify