is it easy to take the part and put back on can it be done by me and also the top part broke would it affect anything underneath the glass thank you.
ANSWER Yolanda, It's basically an easy repair, but cumbersome due to the size of the part and caution needed, because of the glass. As long as there was nothing that dropped through the glass and damaged the element below, you should be fine. Here's some basic information : " CAUTION: When you work on the electric range, be careful when handling the sheet metal parts. Sharp edges may be present, and you can cut yourself if you are not careful. 1. Turn off the electrical supply to the range. 2. Open the oven door and remove the screws
from under the front of the maintop, then close the oven door. 3. Slide the maintop forward as far as possible and remove the ground wire and main harness strain relief from the rear of the maintop. 4. Lay a protective covering between the maintop and the range to protect the finish, then turn the maintop over and lay it on the covering so that you can access the components. 5. Remove the two screws from the bracket of the hot surface indicator light. 6. Remove the screws from the element retaining brackets, unhook them from the maintop,
and remove them. 7. Clean the bottom glass of the new maintop and remove any debris. 8. Lift the elements off the old maintop and place
them on the new maintop at the same locations. 9. Install the new maintop and reassemble the range. REASSEMBLY NOTE: When reinstalling the maintop, make sure that it is centered on the range, that the side brackets are engaged, and that the rear side flanges are
inside the end caps." Thanks and Good Luck
Answered by AppliancePartsPros.com | Thursday, October 27, 2011