Where would we get the step by step instructions to put the helix end cap back on?
ANSWER Lisa, We don't have any written instructions for your particular ice bin. We will be sending you some basic information that should be helpful.In short, you'll remove the bin assembly from thr frezer. Remove to front cover 67004255 from the bin(it snaps on and off), remove the nut from the end of the auger shaft, and the the screws holding the cover 67002271 to the mounting plate. when you remove the blades and spacers, lay them out in order, then you can remove the auger and drive plate D7749401. install the drive on the auger shaft and insert the assembly through the opening in the back of the bin, and reinsall the other parts in reverse order. Thanks
Answered by AppliancePartsPros.com | Friday, August 17, 2012