My dishwasher does not fill. Water supply is good, filters are clean, float is not stuck. Voltage at the switch is 101v. Is it possible that this is a control panel problem or is it the fill valve?
ANSWER Hi Terry. The water valve should get 120vac to opn and fill, not 101 vac. Is there any wires chewed on from the bottom that causes a voltage drop. Is the valve coils ohmming out @ 35-70 ohms? Is the inlet water screen plugged? If You have low voltage at the board output, then back up and see if your door switches supply the board 120vac. Door latch is part # 99002254. Water valve is part # 99001359. Water valve float switch is part # 99002560. Thank you.
Answered by AppliancePartsPros.com | Monday, October 03, 2011